SERVICE BULLETIN NUMBER ST-01-6/81

CATEGORY:    TECHNICAL

ATTENTION:   ALL DMC DEALERS/SERVICE MANAGERS

SUBJECT:     LUGGAGE COMPARTMENT COVER FINISHING MOLDINGS
             SERVICE ACTION SA 0001



Under separate cover, DMC dealers will receive the above molding
materials for certain De Lorean vehicles shipped to them.

These moldings must be installed on the luggage compartment cover
of all De Lorean vehicles not so equipped according to the
instructions on the reverse side.

Please inform all personnel accordingly.

Sincerely,




Lutz Feuerabendt
Technical Service Manager

















                                  (Over)

                                                       ISSUED 6/24/81

             LUGGAGE COMPARTMENT COVER FINISHING MOLDINGS

INSTALLATION

1.  Raise luggage compartment cover and cover fenders.

2.  Using a knife or other suitable tool, cut the supplied molding
    material as follows:

         A.  Two (2) sections 44 inches long
         B.  One (1) section 41½ inches long
         C.  One (1) section 11½ inches long

    NOTE:  Cuts should be 90° square cut.  Do not stretch material
           while measuring.

3.  Apply a thin bead of 3M clear Emblem Adhesive (3M Part No. 08061)
    into the groove of the cut section of molding material prior to
    installation.

4.  With adhesive applied, position the molding sections over the folded
    outer edge of the stainless steel panel and over the outer lip of
    the cover's plastic inner panel as indicated below in Figure 1.


5.  Remove fender covers and close compartment cover.


CLAIM COMPLETION:  Complete DMC Service Transaction form.

LABOR:             Operation Number FL 000 - 25 units (15 minutes)

PARTS:             Not applicable - supplied no charge

LINE B-1:          Enter 30

LINE B-12:         Enter SA 0001