SERVICE BULLETIN NUMBER ST-36-12/81

CATEGORY:    TECHNICAL

ATTENTION:   ALL DMC DEALERS/SERVICE MANAGERS

SUBJECT:     TECHNICAL SERVICE MANUAL

Enclosed with this bulletin is your complimentary copy of the
Technical Service Manual Binder, divider index and Section 4:5,
Automatic Transmission/Final Drive.

Please note and correct the following printing errors.


Page 4:5-7     Governor Control Cable Adjustment     Step 4

      Reads:  between the quadrant arms and the 0.3-0.5mm
              (.012-.020 inch)
Should Read:  between the quadrant arms and the stop peg (E)/
              clearance should be:  0.3-0.5mm (.012-.020 inch)

Page 4:5-25    Figure 4:5-52   Clutch C-1

      Reads:  Tool B.VI. 711
Should Read:  Tool J29351
              Due to production change of C-1 clutch housing
              B.VI. 711 is no longer applicable.  Tool J29351
              is available from Kent-Moore Tools.

Page 4:5-37    Figure 4:5-78

      Reads:  J-28866
              There is no essential tool number for the puller
              shown.  Use any suitable puller when removing
              carrier bearing.

Page 4:5-19    Figure 4:5-42     Transmission End Play Adjustment

      Reads:  Needle
              Needle Bearing
              (Needle Down)
Should Read:  Needle Bearing
              (Needle Up)


                                           Issued 12/30/81

                                          ST-36-12/81
                                          Page 2


Page 4:5-20               Step J               Example

                     Reads:  74.33mm
                            -74.10mm

                               .23mm

               Should Read:  74.33mm
                            -  .23mm

                             71.10mm

Remaining sections of the Technical Service Manual are in process
and will be issued as they are completed.

Please inform all personnel concerned.



Doyle Potter
National Training Manager

DP:mc

Enclosures